Home Assistant – integrating RESTful switches

I have started integrating my IoT-devices and services with the Home Assistant platform. See my previous post for details on getting started with Home Assistant and subscribing to MQTT messages:

Home Assistant – getting started and using MQTT sensors

My next attempt is to configure RESTful switches in HA for interacting with an existing web service that I use for controlling 433 MHz outlets. I will also add automation rules for the switches and test the voice command in Home Assistant.

Continue reading →

Advertisements

Home Assistant – getting started and using MQTT sensors

I’ve been searching for an easy-to-get-started home automation platform that can be extended and customized as my needs grow. After struggling with OpenHAB, Domoticz and Freedomotic, I’ve found Home Assistant to be a much better fit for me. My main requirements are that the system should be open-source, have good tutorials & documentation, work well on a Raspberry Pi and be extensible for my likely future needs. I will spend this and a few upcoming posts with my Home Assistant experiments.

Continue reading →

Monitoring CPU temperatures on a Raspberry Pi with MQTT

Recently I’ve had problems with my Raspberry Pi 3 overheating though I use a heat sink for the processor and have a very modest load on the machine. When the RPi is in this state, it shows a thermometer warning icon and it is not possible to login. As I can not access the machine, it is hard to investigate the cause of the heat problem (if a process has gone totally wild e.g.). The only way to resolve this is to do a hard reboot (then the temperature goes down again).

To investigate this further, I want to monitor the CPU temperature without accessing the RPi via ssh or a direct login. My idea is to let the RPi gather board temperature values regularly and then publish these via MQTT. An MQTT subscriber will see to that the measurements are propagated to a cloud service so that I can monitor the values in an external application. With IFTTT I can add alerts on the measurements (e.g. when the CPU temperature goes over 60 C, an e-mail should be sent to me). This way I will be notified before the temperature/load gets too high and I will hopefully be able to intercept the problem by logging in to the machine before it locks up.

Continue reading →